Hair Bow

Happy New Year!!!

I’ve had a good and mostly productive week this week.

I crossed a fair few things off my ‘To Do’ list and still had time for some relaxing.

I went shopping at the sales, Had afternoon tea with a friend, dyed my hair purple for the new year and spent a whole day reading a new book.  I also did some cooking, tidied the house a little and took down the Christmas decorations.

Hair

I managed to rearrange some of the stuff in my house to set up a craft space in one of the rooms we haven’t been using much. I’m so excited to have a place to leave all my crafty mess that’s not the dining table. I also have access to my sewing machine again!

On the craft front I’ve mostly been working on my planning. I’ve designed and printed a few stickers for my own use and spent a few hours cutting out printed stickers too. I’m working on a project to show how you can still do glam planning with a very small budget.  Now I can get to my sewing machine again I’m planning on working on some sewing projects which I’m sure I’ll share with you later in the year (once I’ve worked them out).

Todays pattern was one I made a few years to make myself a hair bow to match a bow tie I had made for B for a ball.

It’s a fairly simple pattern and doesn’t take a lot of fabric.

Hair Bow

IMG_1626

Materials:

 Pattern (download it here)

Fabric (at least 16×34 cm)

Matching thread

Scissors

Sewing machine or sewing needle

How to:

Assemble pattern. Cut out two pieces from your fabric.

Pin pieces together patterned sides facing each other. Starting near the middle stich around the edge of the pieces. Make sure to leave a 2cm opening.

IMG_1610

Trim corners then turn your work right side out. Use a chop stick or a blunt pencil to push out the corners and edges.

IMG_1613

Iron flat making sure to keep the edges folded in around the opening.  Top stitch the opening shut.

IMG_1615

To create the middle strip for the bow use an off cut or another piece of fabric to create a 1.5x6cm  rectangle with folded edges.  Fold rectangle in half short edges and patterned side together and stitch ends together.

Turn your work right side out which should form a loop.

Fold your bow into 3rds as shown.

Concertina fold bow from top to bottom so it can fit through the loop. Feed one end through the loop until the loop in in the middle of the bow.

That’s the bow done. You can now attach  air clip to the bow or just put the clip through the back of the loop so it is re/moveable.

I hope you enjoy this pattern. Let me know if you give it a go.

Lil.

Leave a Reply

Your email address will not be published. Required fields are marked *